Microe Mercury II 5000 Instrukcja Użytkownika Pobierz pdf (Strona 55)

PurePrecision Laser Tape II Scale Installation

Mercury II PurePrecision Tape and Glass Scales

Installation Manual and Reference Guide

3.3.2 Install Tape Scale Using the Applicator Tool

Use the steps in this section to install PurePrecision Laser Tape II Scales using the hand-held

Applicator Tool. (See Section 3.1.4 Design Guide for details on scale mounting instructions.)

The Applicator Tool

The Hand-Grip Applicator Tool (Model TSAT-PPT) is needed for tape scale lengths greater than

300mm and recommended for lengths of 250mm. It is designed to be handheld and to slide along

either a permanent or temporary mounting edge while the tape scale is supplied.

Applicator Tool Mounting Surface Guide Edges

The applicator tool has two guide edges:

 Low guide edge for configurations of thickness 0.76mm (0.030 inches)

 High guide edge for configurations of thickness greater than 9.5mm (.375 inches)

Refer to the encoder Interface Drawings for tape scale reference edge “D.”

Low Guide Edge

Left end of tool

Grips for Finger Placement

Roller

Reference arrows for tool

and tape scale orientation

Adhesive backing channel

Tape scale entry channel

Adhesive backing exit

Applicator Tool

Low guide edge of tool should

be in contact with mounting

surface edge of thickness

0.76mm (0.030 inches)

Low guide edge

Note: The low guide edge also corresponds to the “D”

tape scale reference edge in the interface drawing.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 69 70

Brak uwag

Microe Mercury II 5000 Instrukcja Użytkownika Strona 55